-
July 2025 by Edward Shaw
took a driveshaft to be legnthened and updated. they legnthend the shaft and did absolutely nothing else charged an astronomical amount to do a full job and didnt replace u-joints pins nothing just legthened it thats it. they didnt reassemble what they said needed taken apart correctly at all it wouldnt make it 6 miles down road before it would come apart
-
January 2025 by Hellbound
First time going to this shop and I will most definitely be going back for any of my repairs. The service was super fast and prices were great, honestly these guys saved me a lot of headache. Highly recommend. If you want affordable Professional service then look no further, this is your place.
-
April 2024 by brian myers
They do great work at a good price
-
February 2024 by steve fisher
Needed new axle u bolts made, and these guys took care of it no problem, very knowledgeable and super fast service had them complete in a few minutes along with a new universal joint and caps, very happy with their work and products made in America the universal joints, doesn't get any better than that
-
January 2024 by Jeremiah Goldsberry
These guys definitely know what they are talking about. Great selection of parts for snowdogg plows and spreaders.
-
January 2024 by matthew mcintyre
More like 0 stars waited 4 hours to get drive shaft cut balanced and u joints installed get home and rear u-joint is installed incorrectly and was charged 170 dollars
-
September 2023 by Patrick Claring
Never made it there
-
August 2023 by Bob Persinger
I went in with my measurements and I was off by and 1 1/4”. They had told mePush it all the way in and pull it out 1 1/2”. When I got there he said 1” instead plus I miss measured the u-joint going into the slip yoke, which he caught as well. So I was off by 1 1/4” total. They r the experts, and this was my first time. He told me that I had to subtract 1 1/4” from my measurement of 39”. I have a pic on my phone from July 12th when I took it to them I showed him the pic of my measurements they r the experts and he said we needed to subtract 1 1/4” from the 39”, which ended up being 37 3/4” so that was the measurement he cut the driveshaft down to come to find out, he should have added it to the length m, and not sub So the driveshaft was toooooooooo short when I picked it up. I installed it because he said it was ok to run it that way. I honestly have not driven it yet, but everyone that has seen it says it will not work. I am going to try to run it this way and see what happens. I am putting plenty of straps above the driveshaft in case it comes out. I want it to work, I really do. Lol. I really hope it does not come out, prey for me, please. Lol
-
August 2023 by Janice Frees
Very knowledgeable and reasonably priced.
-
July 2023 by Roger Wade
Excellent services for heavy trucks.
-
July 2023 by James Hastwell
Parts for 4wheeldrive and suspension customers service is good
-
April 2023 by Roy Baker
Professional knowledgeable and practical. I highly recomend
-
September 2022 by EJ Reviews
Fast, friendly and reasonable prices to fix a small hole in my exhaust system.
-
September 2022 by CJ Moore III
Fantastic Service
-
September 2022 by J D
Good service
